Furuno MFD8 Guía Del Usuario
1. System Introduction
1-5
1.3
Power ON and OFF
Press
to turn the power ON. To turn the power OFF, press and hold the same key
until the screen is black.
When you turn on the power, two or three beeps sound and the lamp near the power
switch lights. The start-up screen appears with the progress bar (at the bottom of the
screen). The progress bar moves to the right as the procedure continues. Approxi-
mately 90 seconds after you apply the power, the Navigation Warning message ap-
pears. Read the message then push the RotoKey to begin operation. (There is an
additional message if your NavNet has the Sirius weather feature.)
switch lights. The start-up screen appears with the progress bar (at the bottom of the
screen). The progress bar moves to the right as the procedure continues. Approxi-
mately 90 seconds after you apply the power, the Navigation Warning message ap-
pears. Read the message then push the RotoKey to begin operation. (There is an
additional message if your NavNet has the Sirius weather feature.)
Note: Do not turn off the power during the start-up sequence. Wait until the procedure
is completed before you turn the power OFF.
is completed before you turn the power OFF.
1.4
Panel Dimmer, Display Brilliance
Adjust the illumination of the panel dimmer and the brilliance of the display as shown
below.
below.
1) Push the
key to display the [Brill/Dimmer] adjustment window.
2) Rotate the RotoKey to adjust the panel dimmer and display brilliance. The current
level is shown on the bar.
3) Push the RotoKey to validate the setting and close the window.
BRILL
BRILL