Furuno MFD8 Guía Del Usuario

1.  System Introduction

The SD card stores the tracks, routes, points, settings, etc. Set and remove SD cards 
as shown below. The recommended capacity for the cards is 128 MB to 2 GB. The 
Secure Digital High Capacity (SDHC) SD cards cannot be used.

You do not normally need to format a SD card for use with the system. If the card be-
comes damaged, format the card with a formatting program that agrees with the spec-
ifications of the SD card. The SD Memory Card Formatting Software made by 
Panasonic is an example.

1) Pull the tab on the card drive cover to open 

the card drive.

2) As shown in the right-hand figure, put the 

SD card in either card drive with the label 
up. If the card does not set easily, do not 
use force.

3) Push the card until the card is in position.

1) Pull the tab on the card drive cover to open 

the card drive.

2) Push the card to release the card from the 

card drive.

3) Remove the card with your fingers then 

close the cover.

•  Use SD cards carefully. Wrong use can damage the card and destroy its contents.

•  Make sure the cover is closed at all times.

•  Remove the card with only your fingers. Do not use metal instruments (like twee-

zers) to remove a card.

•  Do not remove a card during either reading or writing to the card. The power LED 

flashes when the system accesses an SD card.

•  If there is water at the bottom of the card cover, DO NOT open the cover. Re-