Bunn Single SH Guía Del Usuario

Page 17

FIG. 5 BREW SELECTOR SWITCH

P1388

Removal and Replacement:
1. Disconnect the connector on the selector switch

harness from the brewer timer circuit board.

2. Disconnect wires from the selector switch, inter-

face socket, dispense valve and bypass valve.

3. Loosen the set screw on the switch knob.
4. Remove  the  9/16"  nut  and  washer  holding  the

switch to the hood.

5. Remove the switch.
6. Install the new switch. The positioning tab must be

in the hole in the hood for proper switch and knob
alignment.

7. Install the knob so that the arrow lines up in the  1-

1/2  or  1-3/4  gallon  position  when  the  switch  is
turned to the full right position.

8. Reattach the connector to the brew timer circuit

board.

9. Refer to Fig. 5  when reconnecting the wires.

28230 092200