Bunn smartwave aps Guía Del Usuario

Page 10

(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator/display on) enables the brew circuit, and the tank refi ll 
circuit. Pressing the switch again (indicator/display off) stops tank refi lling and brewing. Stopping a brew cycle 
after it has been started will not stop the fl ow of water into the server until the funnel is empty.

NOTE 1: – Stopping a brew cycle by pressing the "ENABLE BREW ON/OFF" switch to the "OFF" position, will dis-
able the tank refi ll circuit. If the level is low enough, tank heating may be disabled as well. Simply pressing the 
"ENABLE BREW ON/OFF" switch to the "ON" position will allow the tank to replenish. Allow a few minutes for the 
tank to heat back up to it's ready temperature.

NOTE 2: – Hot water will be available at the faucet in a limited amount when the "ENABLE BREW ON/OFF" switch 
is in the "OFF" position because the tank will not refi ll. Refer to NOTE 1 regarding low level.

(B) BREW A SWITCH (-)
Momentarily pressing and releasing the switch starts the selected "A" brew cycle when the "ENABLE BREW ON/
OFF" indicator is on. (Factory set for approx. 64 ounces)

(C) BREW B SWITCH (+)
Momentarily pressing and releasing the switch starts the selected "B" brew cycle when the "ENABLE BREW ON/
OFF" indicator is on. (Factory set for approx. 64 ounces)

(E) STATUS DISPLAY
Indicates tank ready, brew cycle, and drip out cycle.

(F) BATCH SIZE/FLAVOR LABELS
Included

40410  092407