Viewsonic PJD6243 Manual De Usuario
26
Start up Screen
Allow you to enter the Start up Screen menu.
• Start up Screen: Select start up screen when the projector is powered on or when
Allow you to enter the Start up Screen menu.
• Start up Screen: Select start up screen when the projector is powered on or when
no signal is input. "User" is the screen that you captured.
• Screen Capture: Capture the current projection screen as a start up screen.
• Screen Capture Delete: Delete the captured projection screen.
Message
Enable or disable the message box at the right bottom of the screen.
Enable or disable the message box at the right bottom of the screen.
Auto Source
Automatically scan through all the input source.
Automatically scan through all the input source.
Power Saving
If the input source is not detected and no operation is performed for a specific period
of time, projector will automatically turn off.
If the input source is not detected and no operation is performed for a specific period
of time, projector will automatically turn off.
Green Mode
Enable this function when power consumption is under 1W.
• Active VGA out: selecting on outputs a VGA signal when the computer in 1 and
Enable this function when power consumption is under 1W.
• Active VGA out: selecting on outputs a VGA signal when the computer in 1 and
computer out sockets are correctly connected to devices. the projector output the
signal received only from computer in 1.
signal received only from computer in 1.
• Active audio out: selecting on output a VGA signal when the computer in1 and
computer out sockets are correctly connected to devices.
Lan control setting
Allow you to configure the LAN settings.
• DHCP: Abbreviation for Dynamic Host Configuration Protocol. This protocol
Allow you to configure the LAN settings.
• DHCP: Abbreviation for Dynamic Host Configuration Protocol. This protocol
automatically assigns IP Address to networked devices.
• When the “DHCP” sets to “On”, it takes some time to obtain IP address from
DHCP server.
• When the "DHCP" sets to "Off", that means user will set IP address by
manually.
• IP Address: Numerical address to identify networked computers. This function can
only be used when DHCP is set to Off.
• The IP Address is the number that identifies this projector on the network. You
cannot have two devices with the same IP Address on the same network.
• The IP Address “0.0.0.0” is prohibited.
• Subent mask: A numeric value to define the number of bits used for a network
address of a divided network (or subnet) in an IP Address. This function can only be
used when DHCP is set to Off.
used when DHCP is set to Off.
• The Subnet Mask “0.0.0.0” is prohibited.
• Default Gateway: A server (or router) to communicate across networks (subnets)
that are divided by Subnet Mask. This function can only be used when DHCP is set
to Off.
to Off.
• DNS: Setup DNS server address when DHCP is disable.