D-Link DAS-3224_revB Manual De Usuario
Getting Started the DAS3series LCT
3
Chapter 2
Getting Started the DAS3series LCT
This chapter describes the DAS3series LCT (Local Craft Terminal), the instructions describes how to
install the DAS3series LCT software and SNMP Service in your MS Windows.
z
install the DAS3series LCT software and SNMP Service in your MS Windows.
z
Installing the Management and Monitoring Tools
z
Install and Uninstall the DAS3series LCT
z
Configuring the DAS3series Community
Installing the Management and Monitoring Tools
The management and monitoring tools for MS Windows can be found by the following steps.
Control Panel Æ Add or remove programs Æ Add/Remove Windows Components
Windows components wizard dialog appear as show in Figure 2-1, check the ‘Management and
Monitoring Tools’ at list box and click ‘Next’ to install the components.
Control Panel Æ Add or remove programs Æ Add/Remove Windows Components
Windows components wizard dialog appear as show in Figure 2-1, check the ‘Management and
Monitoring Tools’ at list box and click ‘Next’ to install the components.
Figure 2-1
Windows Components Wizard Dialog
Once the ‘Management and Monitoring Tools’ component was installed, you have to manually
enable the ‘SNMP Trap Service’ from the Service dialog as show in Figure 2-2.
Start Æ All Programs Æ Administrative Tools Æ Services
If the ‘Administrative Tools’ does not appearing in your All Program menu, point your mouse cursor
at ‘Start’ button and click right mouse button to pop-up the option menu, select the ‘Properties’
customize your Start menu in Advance tag to call the ‘System Administrative Tools’.
at ‘Start’ button and click right mouse button to pop-up the option menu, select the ‘Properties’
customize your Start menu in Advance tag to call the ‘System Administrative Tools’.
DAS3series IP-DSLAM
System Configuration Guide
System Configuration Guide