KitchenAid 30" Hood Liner Uso Y Cuidado

3. If not yet attached, install the 6" (15.2 cm) vent transition the 

top of the range hood liner using two 3.5 x 9.5 mm screws.

4. Locate side mounting bracket flush to the bottom of the 

cabinet side and against the inside of the front cabinet face. 
Orient the bracket depending on the width of your cabinet as 
depicted in the diagrams below. Drill 

¹⁄₈" (3 mm) pilot holes in 

6 places, attach a bracket using three 4.5 x 13 mm screws to 
each side of the cabinet, and tighten. Additional washers in 
hardware package are supplied as spacers for cabinet walls 
thinner than ½" (13 mm).

5. Install the vent system according to the method needed. Use 

caulking to seal the exterior wall or roof opening.

1. Using 2 or more people, lift the hood liner into its mounted 

location. Attach with four 4.2 x 19 mm screws into the slotted 
openings. Do not tighten screws.

2. If needed, insert spacers between each side of the canopy 

and the mounting plate to space and center the canopy in the 
cabinet. Align the bottom of the canopy with the bottom of 
the cabinet. Install four 4.2 x 19 mm screws into the round 
mounting plate openings and tighten all (8) mounting screws.

A filler strip may be required for some cabinets.
Install a filler strip and secure with two 4.5 x 13 mm screws 
from inside the front of the hood liner assembly. 

A

B

C

D

A

B

C

D

A

B

C

D

B

A