Netgear RD5200 (ReadyDATA 5200) – ReadyDATA 5200 System Empty Chassis with 10G (2 port SFP+ card) Guía Del Software
Configure the System Settings
65
ReadyDATA OS 1.4
5.
Configure the settings as explained in the following table:
Item
Description
LACP Mode
Select the LACP mode from the drop-down list:
•
Off. The aggregation interface does not transmit LACPDUs to other LACP
devices or respond to LACPDUs from other LACP devices. Select this mode
for a static LAG. This is the default setting.
devices or respond to LACPDUs from other LACP devices. Select this mode
for a static LAG. This is the default setting.
•
Active. The aggregation interface actively transmits LACPDUs to other LACP
devices to set up a link channel. Select this mode for a dynamic LAG with
active LACP.
active LACP.
•
Passive. The aggregation interface responds only to LACPDUs from other
LACP devices. Select this mode for a dynamic LAG with passive LACP.
LACP devices. Select this mode for a dynamic LAG with passive LACP.
LACP Timer
If the LACP mode is set to Active, select a value for the LACP timer from the
drop-down list:
drop-down list:
•
Short. LACPDUs are sent frequently, with a short interval between LACPDU
transmissions. This is the default setting.
transmissions. This is the default setting.
•
Long. LACPDUs are sent infrequently, with a long interval between LACPDU
transmissions.
transmissions.
Hash Type
Select one or more check boxes to specify the hash types to be used:
•
Layer 2. The channel link that is established is based on the source and
destination MAC addresses.
destination MAC addresses.
•
Layer 3. The channel link that is established is based on the source and
destination IP addresses.
destination IP addresses.
•
Layer 4. The channel link that is established is based on the source and
destination port numbers.
destination port numbers.
6.
Select the Create button.
The new bonded channel displays as an aggregation interface (aggrX, in which X is a
number in sequential and ascending order) on the Network screen.
number in sequential and ascending order) on the Network screen.
7.
To configure the new aggregation interface further, click the gear icon to the right of the
aggregation interface.
aggregation interface.
A pop-up menu displays:
Note:
Both the ReadyDATA and the device with which the channel link is
established must support the same mode.