Xerox WorkCentre 5865/5875/5890 Guía De Administador

Network Connectivity

WorkCentre 5845/5855/5865/5875/5890 Multifunction Printer

System Administrator Guide

4. Touch

DNS Servers.

a. Touch

Primary DNS Server, then type the server address. Touch OK.

b. Touch

Alternate DNS Server #1, then type the server address. Touch OK.

c. Touch

Alternate DNS Server #2, then type the server address. Touch OK.

d. Touch

Close.

Configuring IP Settings in CentreWare Internet Services

If your printer has a valid network address, you can configure TCP/IP settings in CentreWare Internet

Services. For details, see

Assigning a Network Address

on page 19.

Configuring IPv4

You can use IPv4 or IPv6 in addition to or in place of the other.
1. In CentreWare Internet Services, click

Properties > Connectivity > Setup.

2. Under Network, next to a connection type, click

Edit.

Note:

The printer uses separate IPv4, IPv6, and DNS settings for wired and wireless network

connections. Before configuring wireless IP settings, install the Xerox

Wireless Network Interface

and connect to a wireless network. For details, see

Connecting to a Wireless Network

on page 32.

3. Under Configuration Settings, next to IP, click

Edit.

4. Under Protocol, select

Enabled.

5. Under IP Address Resolution, select an option:

−

STATIC disables dynamic addressing and allows you to type a static IP address. Type a

Machine IP Address, Subnet Mask, and Gateway Address.

−

DHCP allows the printer to obtain an IP address from a DHCP server or a BOOTP server that is

configured to accept DHCP requests. The printer requests that the server register the IP address

and hostname of the printer with the DNS server.

−

BOOTP allows the printer to obtain an IP address from a BOOTP server that does not respond

to DHCP requests.

6. Under Broadcast, select

Enabled as needed.

Note:

If the printer does not obtain an IP address from a DHCP/BOOTP server, enable broadcast.

This situation occurs when your DHCP/BOOTP server is on a different subnet than the printer and

communicates through a router acting as a relay agent.

7. In the Zero-Configuration Networking pane, for Self Assigned Address, select

Enabled as needed.

This option instructs the printer to assign itself an address when a DHCP server does not provide

one.

8. Click

Apply.

Note:

If you select Default All, the printer disables FIPS 140 mode.