Craftsman 38907 Manual De Usuario
12
Maintenance (continued)
IMPORTANT! Clean or change the
cartridge fi lter regularly for best
performance.
ALWAYS USE CARTRIDGE FILTER FOR
DRY VACUUMING. If the machine is
used without the cartridge fi lter, the
motor will burn out and the warranty will
be voided.
Always keep spare fi lters on-hand.
cartridge fi lter regularly for best
performance.
ALWAYS USE CARTRIDGE FILTER FOR
DRY VACUUMING. If the machine is
used without the cartridge fi lter, the
motor will burn out and the warranty will
be voided.
Always keep spare fi lters on-hand.
!
WARNING: Always disconnect
the plug from the power outlet
before removing the power head
from the collection tank.
the plug from the power outlet
before removing the power head
from the collection tank.
Installing & Cleaning the Supplied Cartridge Filter
Installing Cartridge Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches and remove the
power head from the collection tank.
3. Place power head on a clean surface in
upside down position.
4. Slide the cartridge fi lter over the fi lter
cage. (Fig. 2) Carefully push fi lter down
until it is fully seated on the power head.
(Fig. 3)
5. To secure fi lter; put on retainer nut and
turn clockwise to tighten until snug. Do
not over tighten. (Fig. 4)
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches and remove the
power head from the collection tank.
3. Place power head on a clean surface in
upside down position.
4. Slide the cartridge fi lter over the fi lter
cage. (Fig. 2) Carefully push fi lter down
until it is fully seated on the power head.
(Fig. 3)
5. To secure fi lter; put on retainer nut and
turn clockwise to tighten until snug. Do
not over tighten. (Fig. 4)
Removing and Cleaning Cartridge Filter
1. Position power head in the upside down
position. If the retainer nut was used to
secure the fi lter, remove retainer nut by
turning counter clockwise.
2. Carefully lift fi lter up from fi lter cage.
(Fig. 5)
1. Position power head in the upside down
position. If the retainer nut was used to
secure the fi lter, remove retainer nut by
turning counter clockwise.
2. Carefully lift fi lter up from fi lter cage.
(Fig. 5)
NOTE: For best cartridge fi lter cleaning
results, cleaning should be conducted
outdoors and not indoors.
results, cleaning should be conducted
outdoors and not indoors.
3. To clean a dry cartridge fi lter after it has
been removed, gently tap it against the
inside wall of the container or brush the
dirt off. Debris will begin to break up,
loosen and fall.
been removed, gently tap it against the
inside wall of the container or brush the
dirt off. Debris will begin to break up,
loosen and fall.
1
2
3
4
5