Craftsman 17608 Manual De Usuario

1.  Verify that the power cord is 
     disconnected from the outlet.  (Fig. 1)
2.  For dry vacuuming, the cartridge filter 
     must be installed correctly.  To verify, 
     please refer to Installing Cartridge Filter
     on page 10. 
3.  Place the power head  back on the 
     collectin tank, and secure it in place 
     using the latches.  (Fig. 2)
4.  Insert the locking end of the hose into 
     the vacuum port and lock in place. 
     Choose the desired accessory and 
     insert onto the end of the hose. (Fig. 3) 
5.  Plug the power cord into the outlet.   
     (Fig. 4)
6.  Turn the motor on by pressing the 
     power switch to the ‘I’ (ON) position 
     and begin vacuuming.  (Fig. 5) 
7.  Once you have completed vacuuming, 
     press the power switch to the ‘O’ (OFF) 
     position and unplug the power cord 
     from the outlet.
     

    

             O = OFF    I = ON                      

DO NOT USE THE CARTRIDGE FILTER 
FOR LIQUID VACUUMING.

7

CAUTION: Do not vacuum drywall dust,
fireplace soot or ash with standard Wet/Dry 
filter. This is very fine dust which will not 
be captured by the filter and may cause 
damage to motor.  When vacuuming fine 
dust use a fine dust filter (sold separately).

WARNING:   Be sure to read, understand and apply all the information in the 
Important Safety Instructions section at the beginning of this operator's 
manual.  Do not vacuum in areas with flammable gases, vapors, or explosive 
dusts in the air.  Flammable gases or vapors include but are not limited to; 
lighter fluid, solvent type cleaners, oil-base paints, gasoline, alcohol or 
aerosol sprays.  Explosive dusts include but are not limited to; coal, 
magnesium, grain or gun powder.  To reduce the risk of health hazards from 
vapors or dust, do not vacuum toxic materials.