Kärcher K3 CAR Manual De Usuario

몇 CAUTION

Prior to extended storage periods, as during the winter, 
also observe the instructions in the Care section.


Park the machine on an even surface.



Push the casing of the quick coupling for the high 
pressure hose toward the rear and disconnect the 
high pressure hose from the appliance.



Press the disconnect on the trigger gun and re-
move the high pressure hose from the trigger gun.



Insert the trigger gun in its holder.



Engage the spray lance in its compartment.



Stow away the mains cable, the high-pressure 
hose and accessory on the appliance.

ATTENTION
Appliances and accessories that are not completely 
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
To avoid damage:


Completely drain all water from the appliance: 
Switch the appliance on with detached high pres-
sure hose and detached water supply (max. 1 min-
ute) and wait, until no more water exits at the high 
pressure connection. Turn off the appliance.



Store the appliance and the entire accessories in a 
frost free room.

 DANGER

Risk of electric shock.


Clean the sieve in the water connection regularly.
ATTENTION
The sieve must not be damaged.


Remove coupling from the water connection.



Pull the sieve out using flat pliers.



Clean the sieve under running water.



Reinsert the sieve into the water connection.

Prior to longer periods of storage, e.g. in the winter:


Remove filter from suction hose for detergent and 
clean under running water.

You can rectify minor faults yourself with the help of the 
following overview. 
If in doubt, please consult the authorized customer ser-
vice.

 DANGER

Risk of electric shock.




Pull on the lever of the trigger gun; the device will 
switch on.



Check whether the voltage indicated on the type 
plate corresponds to the voltage of the mains sup-
ply.



Check the mains connection cable for damages.

Voltage reduction due to weak mains supply or when 
using an extension cable.


When switching on, first pull the lever of the trigger 
gun and then switch the appliance switch to "I/ON".



Check setting at the spray lance.



Check water supply for adequate delivery rate.



Pull out the sieve in the water connection using flat-
nose pliers and clean under running water.



Appliance ventilation: Switch the appliance on with 
the high-pressure hose detached and operate 
(max. 2 minutes) until the water exits the high-pres-
sure connection without bubbles. Switch off appli-
ance and reconnect high-pressure hose.



Clean high-pressure nozzle: Remove dirt and de-
bris from the nozzle bore, using a needle and rinse 
through with water from the front.



Check water flow quantity.



Slight leakage from the appliance pump is normal. 
If the leakage increases contact the authorized 
customer service.



Use spray lance with pressure regulation (Vario 
Power).
Turn the spray lance to "Mix" position.



Clean the detergent suction hose filter.



Check the detergent suction hose for kinks.

Use only original KÄRCHER spare parts. You will find a 
list of spare parts at the end of these operating instruc-
tions.

The warranty terms published by the relevant sales 
company are applicable in each country. We will repair 
potential failures of your appliance within the warranty 
period free of charge, provided that such failure is 
caused by faulty material or defects in manufacturing. In 
the event of a warranty claim please contact your dealer 
or the nearest authorized Customer Service centre. 
Please submit the proof of purchase.
Addresses can be found under:
www.kaercher.com/dealersearch