Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Notas de publicación
2
Release Notes for Cisco ONS 15454 SDH Release 7.0.1
OL-9911-01
Changes to the Release Notes
Changes to the Release Notes
This section documents supplemental changes that have been added to the Release Notes for Cisco ONS
15454 SDH Release 7.0.1 since the production of the Cisco ONS 15454 SDH System Software CD for
Release 7.0.1.
15454 SDH Release 7.0.1 since the production of the Cisco ONS 15454 SDH System Software CD for
Release 7.0.1.
The following changes have been added to the release notes for Release 7.0.1.
Changes to Caveats
Caveats
Review the notes listed below before deploying the ONS 15454 SDH. Caveats with tracking numbers
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
Hardware
CSCed18803
Rarely, the 4x2.5G FEC Muxponder unit does not pass Jitter Tolerance test from Trunk port to client port
as per ITU-T G.825, 2 Mb/s mask, at the 10 Hz specific setpoint. The Muxponder should be configured
with G.709 Off, FEC Off and Trunk signal provided by external Jitter test box, and the unit client port
output monitored for errors, to see this issue. This issue will not be resolved. Note that in normal network
configurations the muxponder is operated with G.709 and FEC turned on, and the jitter tolerance tests
pass.
as per ITU-T G.825, 2 Mb/s mask, at the 10 Hz specific setpoint. The Muxponder should be configured
with G.709 Off, FEC Off and Trunk signal provided by external Jitter test box, and the unit client port
output monitored for errors, to see this issue. This issue will not be resolved. Note that in normal network
configurations the muxponder is operated with G.709 and FEC turned on, and the jitter tolerance tests
pass.
CSCea78210
The TXP_MR_2.5G and TXPP_MR_2.5G cards do not support TX Optical power performance
monitoring on the trunk port. To see this, go to the Optics Performance Monitoring tab of the
TXP_MR_2.5G or TXPP_MR_2.5G card, and select the trunk port. TX Optical Pwr is not shown. This
is as designed.
monitoring on the trunk port. To see this, go to the Optics Performance Monitoring tab of the
TXP_MR_2.5G or TXPP_MR_2.5G card, and select the trunk port. TX Optical Pwr is not shown. This
is as designed.
Maintenance and Administration
Caution
VxWorks is intended for qualified Cisco personnel only. Customer use of VxWorks is not recommended,
nor is it supported by Cisco's Technical Assistance Center. Inappropriate use of VxWorks commands can
have a negative and service affecting impact on your network. Please consult the troubleshooting guide
nor is it supported by Cisco's Technical Assistance Center. Inappropriate use of VxWorks commands can
have a negative and service affecting impact on your network. Please consult the troubleshooting guide