Cisco Cisco IPICS Release 2.1 Instrucciones De Seguridad Importantes

Cisco, Cisco Systems, the Cisco logo, and the Cisco Systems
logo are registered trademarks or trademarks of
Cisco Systems, Inc. and/or its affiliates in the United States
and certain other countries. All other trademarks
mentioned in this document or Website are the property of
their respective owners. The use of the word partner does
not imply a partnership relationship between Cisco and any
other company. (0705R)

© 2007 Cisco Systems, Inc. All rights reserved.

 78-17779-02

Printed in the USA

    DOC-7817779=

You install two Cisco IPICS software 
components:

Cisco IPICS operating system 
software—This installation is 
GUI-based, and you install this 
software from a directly-connected 
console terminal

Cisco IPICS server software—This 
installation is text-based, and you 
install this software from a console 
terminal or a remote console

Perform the following preinstallation tasks 
before you install Cisco IPICS:

Check that you have both CDs from the 
Cisco IPICS installation package.

Attach an Ethernet network cable to the 
NIC1 (eth0) port on your server.

Obtain the IP address, subnet mask, 
default gateway, and DNS server 
information for the Cisco IPICS server.

Obtain multicast IP addresses for 
channels/virtual talk groups (VTGs).

Obtain IP addresses for the router 
media service (RMS) interfaces.

Use the included short-length loopback 
cables to connect the T1/E1 interfaces 
of the RMS. 

If you use the Cisco IPICS policy 
engine, obtain the IP address, SIP 
listening port, and preferred transport 
type of your SIP provider.

If your network uses the Network Time 
Protocol (NTP), obtain the IP address 
or DNS name of the NTP server.

Be aware of the following caveats when you 
install the Cisco IPICS operating system 
software.

If you are installing Cisco IPICS on a 
Cisco media convergence server (MCS) 
7825, you must disable SATA software 
RAID and Virtual Install Disk by 
pressing F10 while the system is 
booting.

If the Kudzu hardware detection 
window displays, press Configure to 
configure the interfaces, Intel SATA 
controller, or Intel IDE controller, as 
prompted. 

For additional information about the 
Cisco IP Interoperability and Collaboration 
System (Cisco IPICS) server installation 
and upgrade procedures, refer to the 

Cisco IPICS Server Installation and 
Upgrade Guide, Release 2.1(1)

.

Refer to the following URL for the 
complete Cisco IPICS documentation set: