Cisco Cisco ONS 15600 Multiservice Switching Platform (MSSP) Guía De Instalación

Read the Release Notes for Cisco ONS 15600 Release 9.1.

Using the CTC software, log into the node that you will upgrade. For detailed instructions, refer to the 
Cisco ONS 15600 Procedure Guide. 

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on the workstation that runs CTC. For 
instructions, contact the Cisco Technical Assistance Center (TAC).

If you have multiple IP addresses on your workstation, you should remove them; you cannot run 
SoftwareR9.1 if multiple IP addresses are configured. 

Verify that TSC cards are installed in Slots 5 and 10, and that the TSC in Slot 10 is active.

If the TSC in Slot 5 is active, select the slot, and right-click to display a menu. Click Soft reset Card. 
The reset takes a few minutes, and resets the TSC card in Slot 10 as the active TSC.

Complete the 

.

Ensure that your workstation is one of the following:

IBM-compatible PC with a Pentium III/700 or faster processor, CD-ROM drive, a minimum of 
384 MB RAM and 190 MB of available hard drive space, running Windows 98, Windows NT 4.0 
(with Service Pack 6a), Windows 2000 Professional (with Service Pack 3), or Windows XP 
Professional (with Service Pack 1)

UNIX workstation with Solaris Versions 8 or 9, on an UltraSPARC or faster processor, with a 
minimum of 384 MB RAM and a minimum of 190 MB of available hard drive space

Ensure that your web browser software is one of the following:

PC or UNIX workstation; Cisco ONS 15600 Software R9.1 (CD or soft 
copy)

Prerequisite Procedures None

Required

Onsite or remote

Superuser

This task verifies that all PC or UNIX workstation hardware and software 
requirements are met.

PC or UNIX workstation

Prerequisite Procedures None

Required

Onsite or remote (but in the presence of the workstation)

Superuser