Cisco Cisco FirePOWER Appliance 8120 Notas de publicación
Version 5.3.0.2
Sourcefire 3D System Release Notes
6
Updating Your Appliances
Updating Your Appliances
To update appliances running at least Version 5.3 of the Sourcefire 3D System to
Version 5.3.0.2, see the procedures outlined below. The following sections help
you to prepare for and install the Version 5.3.0.2 update:
•
•
•
•
WARNING!
Do not reboot or shut down your appliances during the update until
you see the login prompt. The system may appear inactive during the pre-checks
portion of the update; this is expected behavior and does not require you to
reboot or shut down your appliances.
Planning the Update
Before you begin the update, you must thoroughly read and understand these
release notes, especially
on page 3. To ensure a smooth update process, you must also read the
following sections.
Sourcefire 3D System Version Requirements
To update to Version 5.3.0.2, an appliance must be running at least Version 5.3. If
you are running an earlier version, you can obtain updates from the
A Defense Center must be running at least Version 5.3.0.2 to update its managed
devices to Version 5.3.0.2.
The closer your appliances’ current version to the release version (Version
The closer your appliances’ current version to the release version (Version
5.3.0.2), the less time the update takes.
Operating System Requirements
You can host 64-bit virtual Sourcefire virtual appliances on the following hosting
environments:
•
VMware vSphere Hypervisor/VMware ESXi 5.0
•
VMware vSphere Hypervisor/VMware ESXi 5.1
•
VMware vCloud Director 5.1
For more information, see the Sourcefire 3D System Virtual Installation Guide.