Cisco Cisco Content Security Management Appliance M1070 Guía Del Usuario

Unless you are installing a previously-downloaded installer, select an AsyncOS version from the list of 
available upgrades. 

If you are installing: 

Choose whether or not to save the current configuration to the 

configuration

 directory on the 

appliance.

Choose whether or not to mask the passwords in the configuration file.

You cannot load a configuration file with masked passwords using the Configuration File page 
in the GUI or the 

loadconfig

 command in the CLI.

If you want to email copies of the configuration file, enter the email addresses to which you want to 
email the file. Use commas to separate multiple email addresses. 

Click Proceed. 

If you are installing: 

Be prepared to respond to prompts during the process. 

The process pauses until you respond. 

A progress bar appears near the top of the page. 

At the prompt, click Reboot Now. 

Do not interrupt power to the appliance for any reason (even to troubleshoot an upgrade 
issue) until at least 20 minutes have passed since you rebooted. 

After about 10 minutes, access the appliance again and log in. 

If the process was interrupted, you must start the process again. 

If you downloaded but did not install the upgrade: 

When you are ready to install the upgrade, follow these instructions from the beginning, including 
the prerequisites in the Before You Begin section, but choose the Install option. 

If you installed the upgrade, see 

Choose Management Appliance > System Administration > System Upgrade. 

Click Upgrade Options. 

Choose an option: