Cisco Cisco Content Security Management Appliance M1070 Guida Utente
14-25
AsyncOS 8.2 for Cisco Content Security Management User Guide
Chapter 14 Common Administrative Tasks
Step 4
Unless you are installing a previously-downloaded installer, select an AsyncOS version from the list of
available upgrades.
available upgrades.
Step 5
If you are installing:
a.
Choose whether or not to save the current configuration to the
configuration
directory on the
appliance.
b.
Choose whether or not to mask the passwords in the configuration file.
Note
You cannot load a configuration file with masked passwords using the Configuration File page
in the GUI or the
in the GUI or the
loadconfig
command in the CLI.
c.
If you want to email copies of the configuration file, enter the email addresses to which you want to
email the file. Use commas to separate multiple email addresses.
email the file. Use commas to separate multiple email addresses.
Step 6
Click Proceed.
Step 7
If you are installing:
a.
Be prepared to respond to prompts during the process.
The process pauses until you respond.
A progress bar appears near the top of the page.
b.
At the prompt, click Reboot Now.
Note
Do not interrupt power to the appliance for any reason (even to troubleshoot an upgrade
issue) until at least 20 minutes have passed since you rebooted.
issue) until at least 20 minutes have passed since you rebooted.
c.
After about 10 minutes, access the appliance again and log in.
What To Do Next
•
If the process was interrupted, you must start the process again.
•
If you downloaded but did not install the upgrade:
When you are ready to install the upgrade, follow these instructions from the beginning, including
the prerequisites in the Before You Begin section, but choose the Install option.
the prerequisites in the Before You Begin section, but choose the Install option.
•
If you installed the upgrade, see
Viewing Status of, Canceling, or Deleting a Background Download
Procedure
Step 1
Choose Management Appliance > System Administration > System Upgrade.
Step 2
Click Upgrade Options.
Step 3
Choose an option: