Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Referencia técnica

The TSC card has one RJ-45 port of the faceplate. The RJ-45 port allows you to access the system using a 
standard web browser. You must use the RJ-45 port on the active TSC. While using the web browser, you can 
perform local and remote Operations, Administration, Maintenance and Provisioning (OAM&P) functions.

If a browser is not available, you can access the system using one of two RS-232 ports on the Customer 
Access Panel (CAP). Each RS-232 port supports VT100 emulation so that you can enter TL1 
commands directly without using a web browser. Each RS-232 supports its own TL1 session. Because 
the CAP RS-232 port is set up as a DTE interface, you must use a 3-pair swapping null modem adapter 
so that the TXD/RXC, DSR/DTR, and CTS/RTS pins are swapped when connecting to the serial ports. 
The null modem adapter connects the CAP RS-232 port (male configuration) and the serial cable 
(female configuration). Refer to the Cisco ONS 15600 Reference Manual for null modem adapter pin 
assignments.

Attach a 3-pair swapping null modem adapter to the RS-232 port on the CAP. 

Connect a serial cable to the null modem adapter, and to the serial port on your PC or 
workstation.

Complete one of the following:

If you are using a PC, configure the terminal emulation software (Hyperterminal):

Terminal emulation = vt100

Bits per second = 9600

Parity = None

Stop BITS = 1

Flow control = None

If you are using a UNIX workstation, connect from X-windows or the terminal using the 
tip command:

tip -9600 /dev/ttyb (or ttya depending on where serial cable is connected)

Press Enter. A > prompt appears.

You are ready to log into TL1. Follow the steps in the “Log Into TL1” section on page 6.

Once you have connected to TL1, you must log into TL1 in order to issue commands. Logging into 
TL1 only has to be done once per session.