Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Referencia técnica
9
In the “Ten Basic Commands” section on page 9, there are ten commands listed in detail to help get
you started entering TL1 commands.
you started entering TL1 commands.
6
Ten Basic Commands
This section lists ten basic commands to help you get started. You must be connected and logged into
a TL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the
command was completed successfully.
a TL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the
command was completed successfully.
Note
If you receive a DENY response, first check the syntax you entered for accuracy. If you entered
the command correctly, refer to the Cisco ONS SONET TL1 Command Guide for more
information about that particular command and its components.
the command correctly, refer to the Cisco ONS SONET TL1 Command Guide for more
information about that particular command and its components.
Table 2
Some TL1 Category Examples
If You Want to
Look in this Category
Applicable Command or
Autonomous Message
Autonomous Message
Create a 2-fiber or 4-fiber BLSR
BLSR
ENT-BLSR
Delete a cross-connection on a VT
path
path
Cross Connections
DLT-CRS-<PATH>
Set the attributes of the air conditioner Environment Alarms and
Controls
SET-ATTR-CONT
Delete a card from the NE
Equipment
DLT-EQPT
Lockout a user from the NE
Security
INH-USER-SECU
See the alarms on a BITS
Synchronization
REPT ALM BITS
1
1. REPT ALM BITS is an autonomous message. Autonomous messages are either spontaneously triggered by the NE or
scheduled by the NE user via other commands.
Change the date on the NE
System
ED-DAT
Disconnect a test access path/point
Troubleshooting and Test
Access
Access
DISC-TACC
Perform a path protection switch on
an STS path
an STS path
Protection
OPR-PROTNSW-<PATH>
Release a path protection switch on an
STS path
STS path
Protection
RLS-PROTNSW-<PATH>