Cisco Cisco ONS 15310-MA SONET Multiservice Platform Notas de publicación
3
Release Notes for Cisco ONS 15310-MA Release 8.6.1
OL-22859-01
Caveats
CSCsy16814—Traffic is hit when port state is changed from OOS-DSBLD to IS
Traffic is hit when the port state is changed from OOS-DSBLD to IS. This issue is found in CE-MR-6
cards. The workaround is to perform IS->OOS-DSBLD->IS transition until the problem is fixed. This
issue will be resolved in a future release.
cards. The workaround is to perform IS->OOS-DSBLD->IS transition until the problem is fixed. This
issue will be resolved in a future release.
Optical I/O Cards
This section documents caveats for Optical I/O Cards in Release 8.6.1.
CSCsx13871—OC-3 PPM on 15310-MA node does not report PJ-Gen performance monitors
PJ-Gen is not reported for OC-3-rated pluggable port modules (PPM) after you perform the following
tasks:
tasks:
1.
Create an STS-1 circuit on an OC-3-rated PPM.
2.
Enable IIPPM for the same circuit (on the same OC-3 PPM).
3.
Enable PJStsMon on STS-1.
4.
Create a frequency offset into this OC-3 PPM using testset. The same PJ-Gen is not reported in
CTC/TL-1.
CTC/TL-1.
No workaround is available for this issue. This issue will not be resolved.
Maintenance and Administration
This section documents caveats for Maintenance and Administration in Release 8.6.1.
Caution
VxWorks is intended for qualified Cisco personnel only. Use of VxWorks by customers is not
recommended, nor is it supported by the Cisco Technical Assistance Center. Inappropriate use of
VxWorks commands can have a negative and service-affecting impact on your network. Consult the
troubleshooting guide for your release and platform for appropriate troubleshooting procedures. To exit
without logging in, enter a Control-D (press the Control and D keys at the same time) at the Username
prompt. To exit after logging in, type “logout” at the VxWorks shell prompt.
recommended, nor is it supported by the Cisco Technical Assistance Center. Inappropriate use of
VxWorks commands can have a negative and service-affecting impact on your network. Consult the
troubleshooting guide for your release and platform for appropriate troubleshooting procedures. To exit
without logging in, enter a Control-D (press the Control and D keys at the same time) at the Username
prompt. To exit after logging in, type “logout” at the VxWorks shell prompt.
Note
Cisco Transport Controller (CTC) does not support adding or creating more than five circuits in
autoranged provisioning. This restriction is intentional.
autoranged provisioning. This restriction is intentional.
Note
In releases earlier than Cisco ONS Release 4.6, you could independently set proxy server gateway
settings; however, with Cisco ONS Release 4.6.x and later, this is no longer the case. To retain the
integrity of existing network configurations, settings made in a pre-4.6 release are not changed upon
upgrading to Cisco ONS Release 7.x. Current settings are displayed in Cisco Transport Controller
(whether they were inherited from an upgrade or they were set using the current GUI).
settings; however, with Cisco ONS Release 4.6.x and later, this is no longer the case. To retain the
integrity of existing network configurations, settings made in a pre-4.6 release are not changed upon
upgrading to Cisco ONS Release 7.x. Current settings are displayed in Cisco Transport Controller
(whether they were inherited from an upgrade or they were set using the current GUI).