Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Guía De Instalación

—Complete the database backup to ensure 

that you have preserved your node and network provisioning in the event that you need to restore 
them.

—Complete these procedures to 

upgrade the software. You must complete the entire procedure before the upgrade is finished.

—Complete this procedure to 

upgrade the TCC-I card to a TCC2 card.

—As needed, complete this 

procedure to return to the software load you were running before activating the R4.0.x software.

After performing the procedures in this chapter, upgrade the XC10G cards with XCVXL cards, as 
necessary. For detailed instructions, refer to the Cisco ONS 15454 SDH Procedure Guide.

Read the Release Notes for Cisco ONS 15454 SDH Release 4.0.x.

Log into the node that you will upgrade. For detailed instructions, refer to the Cisco ONS SDH 15454 
Procedure Guide.

Complete the 

.

Disable all other Ethernet devices (such as a dial-up adapter) on a PC or workstation that runs CTC. For 
more information, refer to the Cisco Technical Assistance Center (TAC) web site at 
http://www.cisco.com/tac. 

If you have multiple IP addresses on your PC or workstation, you should remove them; you cannot install 
R4.0.x if multiple IP addresses are configured. 

Complete the 

.

Complete the 

When you have completed the procedures for this section, proceed with the 

.

Purpose

This procedure steps you through the critical information checks and 
procedures you must complete before beginning an upgrade.

Tools/Equipment

ONS 15454 SDH nodes to upgrade; PC or UNIX workstation; 
Cisco ONS 15454 SDH R4.0.x software

Prerequisite Procedures

None

Required/As Needed

Required

Onsite/Remote

Onsite or remote

Security Level

Superuser