Cisco Cisco Catalyst 6500 Series Network Analysis Module (NAM-1 NAM-2) Guía De Instalación

 lists the NAM hardware releases that are supported by Catalyst operating system software and 

Cisco IOS software.

Before installing the NAM, you must install the Catalyst 6500 series switch chassis, the Catalyst 6000 
series switch chassis, or the Cisco 7600 series router chassis, and at least one supervisor engine. For 
information on installing the switch chassis, refer to the chassis installation guide.

These tools are required to install the NAM in the Catalyst 6500 series switch, the Catalyst 6000 series 
switch, or the Cisco 7600 series routers:

Flat-blade screwdriver

Phillips-head screwdriver

Wrist strap or other grounding device

Antistatic mat or antistatic foam 

Whenever you handle the NAM, always use a wrist strap or other grounding device to prevent 
electrostatic discharge (ESD).

All Catalyst 6500 series switches, Catalyst 6000 series switches, and Cisco 7600 series routers support 
hot swapping, which allows you to install, remove, replace, and rearrange modules without turning off 
the system power. For more information, see the 

We recommend that you shut down the NAM before you remove the module.

3.

If you are using a 12.1(13)E-based release, we recommend that you use a later 13E release, for example, Release 12.1(13)E11 over 12.1(13)E3.

WS-SVC-NAM-1
WS-SVC-NAM-2

Supervisor Engine 1A or 2 or 
WS-SUP720

Supervisor Engine 1 with 
an MSFC2, Supervisor 
Engine 2 with an MSFC2 
or WS-SUP720

Catalyst 6000 series switches, 
Catalyst 6500 series switches, 
Cisco 7600 series routers