Cisco Cisco VC220 Dome Network Camera Guía De Instalación
VC 220 Dome WDR Day/Night PoE Network Camera Quick Start Guide
3
Before You Begin
Before you begin the installation, make sure that you have the following
equipment and services:
equipment and services:
• At least one computer running Microsoft Internet Explorer 6.x, or later
(other browsers can be used but may have limited functionality)
• An active LAN IP connection
After the basic hardware installation, Cisco strongly recommends that you
run the Setup Wizard on the CD-ROM for first-time software installation of
the camera. Advanced users can set up the Cisco VC 220 directly from the
web interface of the camera.
run the Setup Wizard on the CD-ROM for first-time software installation of
the camera. Advanced users can set up the Cisco VC 220 directly from the
web interface of the camera.
It is suggested that you install the software – see
– before you replace the dome
cover on the camera. This is because after the software is installed, you
will be able to use the web-based configuration utility to see how the lens
should be adjusted and how the camera needs to be focused.
will be able to use the web-based configuration utility to see how the lens
should be adjusted and how the camera needs to be focused.
for instructions on lens
and focusing adjustments, and how to replace the dome cover. The
recommended order of steps is as follows:
recommended order of steps is as follows:
•
“Mounting Your Cisco VC 220 Camera” section on page 8
•
•
•
•
“Adjusting the Lens” section on page 12
•
“Attaching the Dome Cover” section on page 13
The supplied screwdriver is exclusively designed to match the dome
screws, which prevents the cover from being removed by an unauthorized
individual. Do not discard the screwdriver because you may need to
remove the dome cover at a later time.
screws, which prevents the cover from being removed by an unauthorized
individual. Do not discard the screwdriver because you may need to
remove the dome cover at a later time.
1