Cisco Cisco VC220 Dome Network Camera 설치 가이드

Before you begin the installation, make sure that you have the following 
equipment and services:

• At least one computer running Microsoft Internet Explorer 6.x, or later 

(other browsers can be used but may have limited functionality)

• An active LAN IP connection

After the basic hardware installation, Cisco strongly recommends that you 
run the Setup Wizard on the CD-ROM for first-time software installation of 
the camera. Advanced users can set up the Cisco VC 220 directly from the 
web interface of the camera.

It is suggested that you install the software – see 

 – before you replace the dome 

cover on the camera. This is because after the software is installed, you 
will be able to use the web-based configuration utility to see how the lens 
should be adjusted and how the camera needs to be focused. 

See 

 for instructions on lens 

and focusing adjustments, and how to replace the dome cover. The 
recommended order of steps is as follows:

The supplied screwdriver is exclusively designed to match the dome 
screws, which prevents the cover from being removed by an unauthorized 
individual. Do not discard the screwdriver because you may need to 
remove the dome cover at a later time.