Cisco Cisco Unified MeetingPlace Audio Server Manual De Mantenimiento
5-26
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing the hot swap controller
Replacing the hot swap controller
This section provides instructions on how to replace a hot swap controller. The hot swap contoller is
located in slot 10.
located in slot 10.
Warning
Handling the hot swap controller can result in static damage. Use an anti-static wrist strap,
static-dissipating work surface, and anti-static bags when handling and storing the card.
static-dissipating work surface, and anti-static bags when handling and storing the card.
Note
The hot swap controller card always goes into slot 10 in the front of the server. It also has a transition
module in the slot 10 in the back of the server. Whenever the hot swap controller card is replaced, this
transition module must also be replaced.
module in the slot 10 in the back of the server. Whenever the hot swap controller card is replaced, this
transition module must also be replaced.
Removing the old hot swap controller card
Step 1
Verify all steps in the
have been completed.
Step 2
Locate the hot swap controller card in slot 10 in the front of the server. See
Step 3
With a screwdriver, loosen the hot swap controller card’s captive screws at the top and bottom of the
panel. See
panel. See
.
Figure 5-18 Removing the Hot Swap Controller Card and Transition Module
Step 4
Press the ejector levers outward. This partially unseats the hot swap controller card from the backplane
connectors. See
connectors. See
Step 5
Pull the hot swap controller card from the chassis by pressing the ejector levers outward and pulling the
CPU transition module out. See
CPU transition module out. See