Cisco Cisco Unified MeetingPlace Audio Server Maintenance Manual

5-26

Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)

OL-

Chapter 5 Repairing and Maintaining the 8112 Server

Replacing the hot swap controller

This section provides instructions on how to replace a hot swap controller. The hot swap contoller is
located in slot 10.

Warning

Handling the hot swap controller can result in static damage. Use an anti-static wrist strap,
static-dissipating work surface, and anti-static bags when handling and storing the card.

Note

The hot swap controller card always goes into slot 10 in the front of the server. It also has a transition
module in the slot 10 in the back of the server. Whenever the hot swap controller card is replaced, this
transition module must also be replaced.

Removing the old hot swap controller card

Step 1

Verify all steps in the

“Preparing for the repair” section on page 5-2

have been completed.

Step 2

Locate the hot swap controller card in slot 10 in the front of the server. See

Figure 5-6

Step 3

With a screwdriver, loosen the hot swap controller card’s captive screws at the top and bottom of the
panel. See

Figure 5-19

Figure 5-18 Removing the Hot Swap Controller Card and Transition Module