Cisco Cisco 6015 IP DSL Switch
5
Cisco IOS Release 12.2(12)DA
Prerequisites
•
ETSI TS 101 388 V.1.1.1/TM6(98)12 (draft)
•
ETSI TS 102 080 v1.3.2—Support for 2B1Q and 4B3T ISDN
Standard MIBS
•
IETF RFC 1695, Definitions of Managed Objects for ATM Management Version 8.0 using SMIv2
•
IETF RFC 2662, Definitions of Managed Objects for the ADSL Line
•
ADSL Forum TR-006, SNMP-based ADSL Line MIB
•
ADSL Forum TR-014, DMT Line Code Specific MIB
Cisco MIBS
•
CISCO-ADSL-LINE-MIB
•
CISCO-ADSL-DMT-LINE-MIB
To obtain lists of supported MIBs by platform and Cisco IOS release and to download MIBs, go to the
Cisco MIB page at the following URL:
Cisco MIB page at the following URL:
Prerequisites
The 8xDMT over ISDN line card is supported by the following DSLAMs with Cisco IOS Release 12.2(5)DA
or later installed:
or later installed:
•
Cisco 6015 DSLAM
•
Cisco 6260 DSLAM
Note
If you are upgrading from Cisco IOS Release 12.1(5)DA1 or earlier images on the NI-2 card to
Release 12.2(5)DA or later, you must reformat the boot flash memory on the NI-2 card. See the
Release Notes for Cisco IOS Release 12.2(5)DA for instructions.
Release 12.2(5)DA or later, you must reformat the boot flash memory on the NI-2 card. See the
Release Notes for Cisco IOS Release 12.2(5)DA for instructions.
Note
If you are using an Alcatel-based CPE, a Cisco SOHO 76 CPE, or a Cisco 826 CPE, see the operational
requirements for those CPEs in the
requirements for those CPEs in the
Configuration Tasks
The following sections describe how to configure the 8xDMT over ISDN line card for operation:
•
(optional)
•
(required)
•
(optional)