Cisco Cisco Aironet 1240 AG Access Point Notas de publicación
11
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(10b)JA1
OL-15533-01
Important Notes
This example shows the commands that you use to re-enable the radio:
AP1242AG(config)# interface d1
AP1242AG(config-if)# shut
AP1242AG(config-if)# no mbssid
AP1242AG(config-if)# no shut
After you re-enable the radio, you can enable VLANs on the access point and enable multiple BSSIDs.
Cannot Set Channel on DFS-Enabled Radios in Some Regulatory Domains
Access points with 5-GHz radios configured at the factory for use in Europe, Singapore, Korea, Japan,
Taiwan, and Israel now comply with regulations that require radio devices to use Dynamic Frequency
Selection (DFS) to detect radar signals and to avoid interfering with them. You cannot manually set the
channel on DFS-enabled radios configured for these regulatory domains.
Taiwan, and Israel now comply with regulations that require radio devices to use Dynamic Frequency
Selection (DFS) to detect radar signals and to avoid interfering with them. You cannot manually set the
channel on DFS-enabled radios configured for these regulatory domains.
Cisco 7920 Phones Require Firmware Version 1.09 or Later When Multiple
BSSIDs Are Enabled
BSSIDs Are Enabled
When multiple BSSIDs are configured on the access point, Cisco 7920 wireless IP phones must run
firmware version 1.09 or later.
firmware version 1.09 or later.
GRE Tunnelling Through WLSM Sometimes Requires MTU Setting Adjustments
If client devices on your wireless LAN cannot use certain network applications or cannot browse to
Internet sites, you might need to adjust the MTU setting on the client devices or other network devices.
For more information, refer to the Tech Note at this URL:
Internet sites, you might need to adjust the MTU setting on the client devices or other network devices.
For more information, refer to the Tech Note at this URL:
TACACS+ and DHCP IP Address Sometimes Locks Out Administrators
When you configure an access point for TACACS+ administration and to receive an IP address from the
DHCP server, administrators might be locked out of the access point after it reboots if the administrator
does not have a local username and password configured on the access point. This issue does not affect
access points configured with a static IP address. Administrators who have been locked out must regain
access by resetting the unit to default settings.
DHCP server, administrators might be locked out of the access point after it reboots if the administrator
does not have a local username and password configured on the access point. This issue does not affect
access points configured with a static IP address. Administrators who have been locked out must regain
access by resetting the unit to default settings.
Access Points Do Not Support Loopback Interface
You must not configure a loopback interface on the access point.
Caution
Configuring a loopback interface might generate an IAPP GENINFO storm on your network and disrupt
network traffic.
network traffic.