Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica
10
Cisco ONS 15454 SDH, Cisco ONS 15600 SDH, and Cisco ONS 15310-MA SDH. For a complete list
of categories, commands and autonomous messages, refer to the, Cisco ONS SDH TL1 Command
Guide.
of categories, commands and autonomous messages, refer to the, Cisco ONS SDH TL1 Command
Guide.
In the “6. Basic Commands” section on page 10, there are various commands listed in detail to help
get you started on using the TL1 commands.
get you started on using the TL1 commands.
6
6. Basic Commands
This section lists the basic commands to help you get started. You must be connected and logged into
aTL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the
command was completed successfully.
aTL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the
command was completed successfully.
Table 3
Some TL1 Category Examples
If You Want to
Look in this Category
Applicable Command or
Autonomous Message
Autonomous Message
Create a 2-fiber or 4-fiber MS-SPRing MS-SPRing
ENT-<MOD_RING>
Delete a cross-connection on a VC
path
path
Cross Connections
DLT-CRS-<PATH>
Set the attributes of the air conditioner Environment Alarms and
Controls
SET-ATTR-CONT
Delete a card from the NE
Equipment
DLT-EQPT
Lockout a user from the NE
Security
INH-USER-SECU
See the alarms on a BITS
Synchronization
REPT ALM BITS
1
1. REPT ALM BITS is an autonomous message. Autonomous messages are either spontaneously triggered by the NE or
scheduled by the NE user via other commands.
Change the date on the NE
System
ED-DAT
Disconnect a test access path/point
Troubleshooting and Test
Access
Access
DISC-TACC
Perform an SNCP protection switch on
an VC path
an VC path
Protection
OPR-PROTNSW-<PATH>
Release an SNCP protection switch on
an VC path
an VC path
Protection
RLS-PROTNSW-<PATH>