Cisco Cisco Catalyst 6500 Cisco 7600 Router Traffic Anomaly Detector Module Notas de publicación

The following new features are available in software version 6.0(5):

Ability to set the TACACS+ sever port.

Ability to set the TACACS+ encryption key.

The Detector module can now operate at two different bandwidth performance levels: 1 Gigabit per 
second (Gbps) or 2 Gbps. The software image that is loaded on the Detector module determines the 
operating bandwidth by controlling the three physical interfaces between the module and the 
supervisor engine. The available software images control the interfaces in the following ways:

6.0—This software image provides 1-Gbps throughput, allowing data traffic to move between 
the supervisor engine and the Detector module over a single interface port that has a maximum 
bandwidth of 1 Gbps. A second interface port is used to transport out-of-band management 
traffic and activate associated Guard devices. The third interface port is not used. 

6.0-XG—This software image provides 2-Gbps throughput, enabling two of the interface ports 
for transporting data traffic. The third interface is dedicated to transporting out-of-band 
management traffic and activating Guard devices. To use the XG software image, the Detector 
module requires a software license key.

When you order a 6.0-XG Detector module, Cisco installs the software license key with the 
6.0-XG software image. When you order a 6.0-XG software image as a spare to upgrade an 
existing Detector module, you must obtain and install the software license key to activate the 
software image. For more information, see the 

 section.

When you order a 6.0-XG software image as a spare to install in an existing Detector module, you must 
enter a software license key to activate the software image. This section contains the following topics 
that describe how to order and install a software license key:

The software license key that is required to activate the XG software image is associated with the Media 
Access Control (MAC) address of the Detector module where the XG software image resides. This 
section describes the process that you use to order the XG software license key.

You must have the XG version of the 6.0 operating software (or newer) loaded on your Detector module 
before ordering and installing the corresponding license. To verify the version of software currently 
loaded on your Detector module, use the show version command. When the XG software image is 
loaded, the software version number has an -XG suffix (for example, version 6.0(0.39)-XG).