Cisco Cisco Catalyst 6500 Cisco 7600 Router Traffic Anomaly Detector Module Notas de publicación

Install the required version of the software image by using one of the following methods:

FTP or TFTP method from the Catalyst 6500 Series Switch or the 7600 series router

Inline method using the upgrade command

Reboot the Detector module back to the AP. 

hw-module module module number reset cf:4

After the reboot, a message displays prompting you to provide new passwords upon the first login. The 
prompt for new passwords verifies that the clear ap config command was executed successfully in 
Step 4. The initial reboot after a downgrade may include an automatic flash-burn due to a Common 
Firmware Environment (CFE) version change, which may cause the reboot to take longer than usual.

Verify that the desired version is installed in the Detector module by entering the following command in 
the global mode of the Detector module CLI:

After you downgrade the software image, you must reconfigure the Detector module either manually or 
by using the running-config file that you saved to a network server prior to the downgrade. 

If you use the running-config file to reconfigure the module, you must verify that the network 
configurations are configured properly according to the software version that you install. For example, 
the interface names may be different between the previously installed version of the software and the 
currently installed version. You can modify the running-config file using one of the following methods:

Edit the network configuration portion of the running-config file prior to importing the file.

Delete network configuration information from the running-config file before you import the file 
and then configure the network configuration manually either before or after you import the file. 

Refer to the version of the Cisco Traffic Anomaly Detector Module Configuration Guide that applies to 
the software version you are running for more information about configuring the network parameters and 
to the applicable Detector module release notes for information about network configuration differences.

The Catalyst 6500 9-slot chassis supports a combined maximum of eight Anomaly Guard modules and 
Traffic Anomaly Detector modules. You can install a maximum of eight Guard modules or a maximum 
of four Detector modules in a single chassis in any combination for a total of eight modules.

A Catalyst 6500 13-slot chassis supports a combined maximum of 10 Anomaly Guard modules and 
Traffic Anomaly Detector modules. You can install a maximum of eight Guard modules or a maximum 
of four Detector modules in a single chassis in any combination for a total of 10 modules.