Cisco Cisco D9824 Advanced Multi Decryption Receiver Guía De Instalación
Configuring Transport Stream Information
78-4039426-01 Rev D
177
19 Click OK.
20 The MoIP Output Status section displays the current Output bit Rate (0 to 213
20 The MoIP Output Status section displays the current Output bit Rate (0 to 213
Mbps) and the available bit bandwidth (Free Bandwidth), in Mbps.
Note: Free Bandwidth will always display zero.
Note: Free Bandwidth will always display zero.
21 Click Apply.
If a conflict occurs, a detailed error message appears at the top of the page. You
must resolve the conflict and then click Apply to save and apply your changes
again.
must resolve the conflict and then click Apply to save and apply your changes
again.
Configuring the DPM MPEGoIP Output Details
The following procedure defines all the available fields. For a typical setup of the
DPM, see Typical set up for Digital Program Mapping (see "Typical set up for
Digital Program Mapping (DPM)" on page 182).
DPM, see Typical set up for Digital Program Mapping (see "Typical set up for
Digital Program Mapping (DPM)" on page 182).
Note: After you make any changes, a successfully updated (session open) message
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
1 From the user interface of the D9824, click Transport Stream > Transport
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
1 From the user interface of the D9824, click Transport Stream > Transport
Handling, expand MPEG over IP Output and then click Digital Program
Mapping. The Digital Program Mapping page is displayed.
Mapping. The Digital Program Mapping page is displayed.