Cisco Cisco Aironet 1200 Access Point Notas de publicación

IOS (tm) C1200 Software (C1200-K9W7-M), Version 12.2(15)JA

Copyright (c) 1986-2004 by Cisco Systems, Inc.

On access points running Cisco IOS software, you can also find the software version on the System 
Software Version page in the access point’s web-browser interface. If your access point runs VxWorks 
software, the software version appears at the top left of most pages in the web-browser interface. 

For instructions on installing access point software:

Follow this link to the Cisco Aironet Install and Upgrade page:

Click this link to browse to the Cisco IOS Software Center on Cisco.com:

Log into Cisco.com to use the Cisco IOS Upgrade Planner. 

If your 350 or 1200 series access point does not run IOS software, you can use the conversion utility or 
the conversion upgrade image to convert the access point system to IOS software. Use the conversion 
utility to maintain the current configuration after the conversion, or load the upgrade image to convert 
to IOS software without saving the current configuration. Your access point must be running one of these 
VxWorks firmware versions before you can convert to IOS software:

350 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 11.23T, or 
11.21

1200 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 12.00T, 
11.56, or 11.54T

The upgrade image and the conversion tool do not support VxWorks version 12.04. Access points 
running version 12.04 must be downgraded to a supported operating system version before you can use 
the upgrade image or the conversion tool.

The upgrade to Cisco IOS software is permanent; you cannot revert to non-IOS software. Product 
warranties do not cover unintended upgrades. 

For complete instructions on using the conversion utility, refer to the Cisco Aironet Conversion Tool for 
Cisco IOS Software, 2.0 Administrator Guide for Windows. Click this link to browse to the Administrator 
Guide: