Cisco Cisco Aironet 1200 Access Point Notas de publicación
5
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)XR2
OL-6548-01
Installation Notes
Caution
The power injector does not provide fire resistance and low smoke-producing characteristics and is not
intended for use in extremely high or low temperatures or in environmental air spaces, such as above
suspended ceilings.
intended for use in extremely high or low temperatures or in environmental air spaces, such as above
suspended ceilings.
Note
If you plan to mount a 1200 series access point with a 5-GHz radio in an area subject to environmental
air space, Cisco recommends that you mount the access point horizontally so that its antennas point
down. Doing so ensures that the access point complies with regulatory requirements for environmental
air space with the 5-GHz radio installed.
air space, Cisco recommends that you mount the access point horizontally so that its antennas point
down. Doing so ensures that the access point complies with regulatory requirements for environmental
air space with the 5-GHz radio installed.
Power Considerations
This section describes issues you should consider before applying power to an access point.
Caution
The operational voltage range for 1100 series access points is 24 to 60 VDC, and the nominal voltage is
48 VDC. Voltage higher than 60 VDC can damage the equipment.
48 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
The nominal voltage for 1200 series access points is 48 VDC, and the access point is operational up to
60 VDC. Voltage higher than 60 VDC can damage the equipment.
60 VDC. Voltage higher than 60 VDC can damage the equipment.
Caution
Cisco Aironet power injectors are designed for use with Cisco Aironet access points and bridges only.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.
Do not use the power injector with any other Ethernet-ready device. Using the power injector with other
Ethernet-ready devices can damage the equipment.
Note
The WS-F6K-PWR power over Ethernet (PoE) daughtercard in a Catalyst 6500 series switch cannot
supply power to a 1200 series access point. Using a Catalyst 6500 series switch for inline power requires
the WS-F6K-FE48-AF, WS-F6K-GE48-AF, or WS-F6K-VPWR-GE PoE daughtercard.
supply power to a 1200 series access point. Using a Catalyst 6500 series switch for inline power requires
the WS-F6K-FE48-AF, WS-F6K-GE48-AF, or WS-F6K-VPWR-GE PoE daughtercard.
Use Only One Power Option
You cannot provide redundant power to 1100 and 1200 series access points with both DC power to its
power port and inline power from a patch panel or powered switch to the access point’s Ethernet port. If
you apply power to the access point from both sources, the switch or power patch panel might shut down
the port to which the access point is connected.
power port and inline power from a patch panel or powered switch to the access point’s Ethernet port. If
you apply power to the access point from both sources, the switch or power patch panel might shut down
the port to which the access point is connected.
shows the power configuration that can shut
down the port on the patch panel or powered switch.