Cisco Cisco Web Security Appliance S190 Guía Del Usuario
C H A P T E R
27-1
Cisco IronPort AsyncOS 7.7 for Web User Guide
27
Command Line Interface
•
•
•
•
The Command Line Interface Overview
The AsyncOS Command Line Interface (CLI) is an interactive interface designed to allow you to
configure and monitor the Web Security appliance. The commands are invoked by entering the command
name with or without any arguments. If you enter a command without arguments, the command prompts
you for the required information.
configure and monitor the Web Security appliance. The commands are invoked by entering the command
name with or without any arguments. If you enter a command without arguments, the command prompts
you for the required information.
The Command Line Interface is accessible using SSH on IP interfaces that have been configured with
these services enabled, or using terminal emulation software on the serial port. By default, SSH is
configured on the Management port.
these services enabled, or using terminal emulation software on the serial port. By default, SSH is
configured on the Management port.
Using the Command Line Interface
This section describes the rules and conventions of the AsyncOS Command Line Interface.
Accessing the Command Line Interface
Access to the CLI varies depending on the management connection method chosen while setting up the
appliance. The factory default username and password are listed next. Initially, only the admin user
account has access to the CLI. You can add other users with differing levels of permission after you have
accessed the CLI for the first time using the admin account. The System Setup Wizard prompts you to
change the password for the admin account.
appliance. The factory default username and password are listed next. Initially, only the admin user
account has access to the CLI. You can add other users with differing levels of permission after you have
accessed the CLI for the first time using the admin account. The System Setup Wizard prompts you to
change the password for the admin account.
You can also reset the admin account password at any time using the
passwd
command.
You can connect using one of the following methods:
•
Ethernet. Start an SSH session with the IP address of the Web Security appliance. The factory
default IP address is 192.168.42.42. SSH is configured to use port 22.
default IP address is 192.168.42.42. SSH is configured to use port 22.