Cisco Cisco Web Security Appliance S370 Guía Del Usuario

Appliance physical connections. Plug the Ethernet cables into the 
appropriate ports on the back panel of the appliance. For details, see 

.

Setup information. Once you know how you will install the appliance in 
your network, gather all the information, such as IP addresses, necessary for 
the System Setup Wizard. For details, see 

.

Existing proxy server. If you plan to use the Web Security appliance in a 
network that has an existing proxy server, you must locate it downstream 
from other proxy servers. Also, after you finish the initial setup of the 
appliance, you must configure it to work with the existing proxy server. For 
more information about deploying the appliance in a network with an existing 
proxy, see 

In order to run the System Setup Wizard the first time, you must connect a 
computer, such as a laptop, to the appliance. To connect to the appliance, the 
laptop subnet must be the same as the appliance subnet. The Management ports 
are labeled M1 and M2. The Web Security appliance only uses the M1 
Management port. It does not use M2.

Configure the laptop IP address so it is on the same subnet as the appliance 
(192.168.42.xx). Then, connect the laptop to the M1 port on the back of the 
appliance.

You must plug the Ethernet cables into the appropriate ports on the back panel of 
the appliance. For more information about the Ethernet ports on the appliance, see 

How you deploy the appliance determines which Ethernet cables to plug in where: