Cisco Cisco Catalyst 6500 Series 7600 Series ASA Services Module Guía De Instalación

The ASA Services Module has a recessed switch, labeled SHUTDOWN, mounted on the module front 
panel. If a fault is detected on the ASA Services Module, the operator must press the SHUTDOWN 
switch to interrupt the Services module processors and initiate an orderly shutdown of the storage 
devices on the module before the module is removed from the chassis.

These tools are required to install the ASA Services Module in the chassis:

Small flat-blade screwdriver

No. 2 Phillips screwdriver

Antistatic mat or foam pad to support the module 

Your own ESD-prevention equipment or the disposable grounding wrist strap included with the 
module

Switching-module filler plates (Cisco part number SLOTBLANK-09 or WS-X6K-SLOT-CVR-E). 
Replaces blank slot covers in slots that are directly adjacent to the Services Module slot (either 
above and below on horizontal slot chassis or left and right on vertical slot chassis).

If you are installing one or more of the Cisco Services Modules in your chassis that are listed in 

, 

the slots directly adjacent to the services module (above and below or to the left and to the right) must 
contain either line cards or switching-module filler plates (Cisco part numbers WS-X6K-SLOT-CVR-E 
or SLOTBLANK-09). If either adjacent slot is unused and currently has a blank slot cover (Cisco part 
number WS-X6K-SLOT-CVR) installed, you must remove the blank slot cover and replace it with a 
switching-module filler plate for NEBS compliance. 

For NEBS compliance when installing Cisco Services Modules, refer to 

To prevent ESD damage, handle the module by the metal carrier edges only.

WS-SVC-NAM3-6G-K9(=)

WS-SVC-ASA-SM1-K7(=)

WS-SVC-ASA-SM1-K8(=)

WS-SVC-ASA-SM1-K9(=)