Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Guía De Instalación

Using the thumb and forefinger of each hand, simultaneously push in the left and right levers to fully 
seat the SSL Services Module in the backplane connector.

Always use the ejector levers when installing or removing the SSL Services Module. A module that is 
partially seated in the backplane will cause the system to halt and subsequently crash.

If you perform a hot swap, the console displays the message “Module n has been inserted.” This 
message does not appear if you are connected to the Catalyst 6500 series switch through a Telnet 
session.

Use a screwdriver to tighten the captive installation screws on the left and right ends of the SSL Services 
Module.

This completes the SSL Services Module installation procedure.

When you install the SSL Services Module into the Catalyst 6500 series switch, the module goes through 
a boot sequence that requires no intervention. At the successful conclusion of the boot sequence, the 
green STATUS LED will light and remain on. If the STATUS LED is not green, or is a different color, 
see 

 to determine the module’s status.

SUPERVISOR I

WS-X6K-SUP1

STATUS SYSTEMACTIVE PWR MGMT

RESET

CONSOLE

Switch    Load   

100%

1%

CONSOLE

PORT

MODE

PCMCIA

EJECT

PORT 1

LINK

PORT 2

LINK

16059

Captive
installation 
screws

Ejector lever