Cisco Cisco UCS C460 M1 High-Performance Rack-Mount Server Hoja De Datos
Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Large Form Factor Hard Disk Drive Model)
8
BASE SERVER STANDARD CAPABILITIES and FEATURES
BASE SERVER STANDARD CAPABILITIES and FEATURES
lists the capabilities and features of the base server. Details about how to configure the server for
a particular feature or capability (for example, number of processors, disk drives, or amount of memory)
are provided in
are provided in
.
Table 1 Capabilities and Features
Capability/Feature
Description
Chassis
One rack unit (1RU) chassis
CPU
One or two Intel® Xeon E5-2600 v2 or E5-2600 series processor family CPUs
Chipset
Intel® C600 series chipset
Memory
16 slots for registered or unbuffered ECC DIMMs (RDIMMs or UDIMMs) or
load-reduced DIMMs (LRDIMMs)
Multi-bit Error
Protection
This server supports multi-bit error protection.
NIC
Embedded dual-port Intel i350 PCIe-based Gigabit Ethernet controller, supporting
the following:
■
Pre-Execution Boot (PXE boot)
■
iSCSI boot
■
Checksum and segmentation offload
■
NIC teaming
Expansion slots
Two PCIe slots (on a riser card)
■
One full-height profile, half-length slot with x24 connector and x16 lane
■
One half-height profile, half-length slot with x16 connector and x8 lane
Internal storage
devices
Drives are installed into front-panel drive bays that provide hot-pluggable access.
■
Large Form Factor (LFF) drives. Up to four 3.5-inch SAS or SATA
hot-swappable hard disk drives (HDDs).
■
The server also contains one internal USB 2.0 port on the motherboard that
you can use with a USB thumb drive for additional storage.
■
UCS Storage Accelerator are also available. These PCIe flash storage devices
provide independent high-speed storage.
Cisco Flexible
Flash drives
The server supports up to two internal 32 GB Cisco Flexible Flash drives (SD cards).
The second SD card is blank and can be used to mirror the first SD card. It can be
The second SD card is blank and can be used to mirror the first SD card. It can be
used to protect the Hypervisor Partition with RAID1.