Cisco Cisco UCS B200 M3 Blade Server Hoja De Datos
Cisco UCS B22 M3 Blade Server
38
SUPPLEMENTAL MATERIAL
Upgrade and Servicing-Related Parts
This section lists the upgrade and servicing-related parts you may need during the life of your server. Some
of these parts are configured with every server or with every UCS 5108 blade server chassis, and some may
be ordered when needed or may be ordered and kept on hand as spares for future use. See
of these parts are configured with every server or with every UCS 5108 blade server chassis, and some may
be ordered when needed or may be ordered and kept on hand as spares for future use. See
Drive and Blade Server Blanking Panels
A drive blanking panel (N20-BBLKD=) must be installed if you remove a disk drive from a UCS server.
Similarly, a blade server blanking panel (N20-CBLKB1=) must be installed if you remove a half-width blade
server (such as a UCS B22 M3 server) from a blade server chassis. These panels are required to maintain
system temperatures at safe operating levels, and to keep dust away from system components.
Similarly, a blade server blanking panel (N20-CBLKB1=) must be installed if you remove a half-width blade
server (such as a UCS B22 M3 server) from a blade server chassis. These panels are required to maintain
system temperatures at safe operating levels, and to keep dust away from system components.
Adding an Additional CPU (with CPU heat sink)
All Cisco UCS two CPU socket-capable servers can be upgraded from having one to having two CPUs
configured. You will need to order and install a heat sink when adding any additional CPU to a server.
Instructions for installing the new CPU and heat sink can be found at the following link:
configured. You will need to order and install a heat sink when adding any additional CPU to a server.
Instructions for installing the new CPU and heat sink can be found at the following link:
Motherboard Lithium Battery
You can order a replacement motherboard battery. Installation instructions are found at this link:
Table 25 Upgrade and Servicing-related Parts for UCS B22 M3 Server
Spare Product ID (PID)
Description
N20-BBLKD=
2.5-inch HDD Blanking Panel
1
Notes
1. This part is included/configured with your UCS server (in some cases, as determined by the configuration of
your server).
N20-CBLKB1=
Blade slot blanking panel for UCS 5108/single slot
2
N20-BHTS1=
CPU heat sink for UCS B22 M3 and B200 M1/M2 Blade Servers
1
UCS-CPU-LPCVR-EN=
CPU load plate dust cover (for unpopulated CPU sockets)
UCSB-BAFF-B22-M3=
Air Baffle Replacement Kit for B22 M3 Server
1
N20-MBLIBATT=
Replacement Lithium Battery for Server Motherboard (CR2032)
1
N20-BKVM=
KVM local IO cable for UCS servers console port
2
2. This part is included/configured with the UCS 5108 blade server chassis.
UCS-CPU-EP-PNP=
Pick n place CPU tool set (for Intel E5 EP Socket R)
3
3. This part is included with the purchase of an optional or spare CPU processor kit.
UCS-CPU-GREASE=
CPU thermal grease syringe - needed for heat sink seal
3
UCSX-HSCK=
UCS Processor Heat Sink Cleaning Kit (when replacing a CPU)
3