Cisco Cisco MGX 8880 Media Gateway Notas de publicación
8
Release Notes for Cisco Voice Switch Service Module (VXSM) Release 5.0.02
Part Number OL-6224-01 Rev. A0, September 1, 2004
Caveats for VXSM Release 5.0.02
Resolved Caveats in Release 5.0.02
describes the open caveats that existed in VXSM Release 5.0.00 and are now resolved in Release
5.0.02.
.
CSCef59551
Headline: Call failures at high call rate with announcements
Symptom: At high call rates when announcements are played, some calls will fail
with error code 500. (The failure is caused because of a race condition between an
announcement stop request and the subtraction of the termination.)
with error code 500. (The failure is caused because of a race condition between an
announcement stop request and the subtraction of the termination.)
Conditions: This would happen when announcements are played on some
terminations. The exact scenario that causes this is still under investigation.
terminations. The exact scenario that causes this is still under investigation.
Workaround: None.
CSCin76515
Headline: Few lines go down on VXSM 48T1E1 after VXSM switchover.
Symptom: When vxsm card with 48 T1E1 back card is in 1:1 redundancy configuration
and when slot 4 or slot 12 become active during switchover some lines may report alarms.
and when slot 4 or slot 12 become active during switchover some lines may report alarms.
Conditions: The alarms condition occur only for slot 4 or slot 12 with Redundant back
card and also these slot become active due to failover from slot 3 or slot 11 (adjacent slot)
redundant pair.
card and also these slot become active due to failover from slot 3 or slot 11 (adjacent slot)
redundant pair.
Workaround: None
Further Problem Description:Reconfiguring the certain device register to resolve these
alarms
alarms
CSCuk52672
Headline: VXSM sends error 430 when receives NULL context audit on busy term
Symptom: 430 error code is used when MGC sends a audit in null context for a termina-
tion that is actually in context. 435 should be used instead.
tion that is actually in context. 435 should be used instead.
Conditions: MGC must be auditing a termination that is in a context
Workaround: None
Table 4
Open Software Caveats for VXSM Release 5.0.02 (continued)
DDTS Issue
Description
Table 5
Release 5.0.00 Caveats that are resolved in Release 5.0.02
DDTS Issue
Description
CSCed84520
Bulk delcid/addcid fails intermittently on OC3 card.
CSCed88312
CID alarm not reported for last cid when ds1 is in alarm.
CSCed92138
VXSM reports presence of RCON when there is none installed.
CSCed93276
It takes 1 minute to connect to MGC after MGC switchover.
CSCed93674
VXSM HSS Toolkit Suspend while IP network outage.
CSCed95634
VXSM card comes in Failed state after card reinsertion.
CSCee01411
MCCI memory allocation failure for play tone list inside sequential.
CSCee02176
Race condition in crml when stream_del/res_dealloc flow is changed.
CSCee02614
With Back Card failure APS fails to respond