Cisco Cisco Aironet 1310 Access Point Bridge Guía De Instalación

Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) 
requirements in IEC 60950 based safety standards. Statement 1033

Only a qualified electrician or service person should make and install the power cable with in-line fuse 
supplying DC-power to the power injector.

To prevent damage to the bridge or power injector, connect all coax cables from the power injector to 
the bridge and connect the power jack to the power injector before applying power.

The power plug has a screw-on cap to secure the power cable to the power injector. The mating power 
plug is a Switchcraft 760K (see 

).

When you mount the bridge in a vehicle, an inline power fuse must be used in the positive (+) power line 
going to the power injector.

The inline power fuse must be listed and certified to the appropriate safety standards for the country 
where the bridge is installed.

 provides the inline power fuse requirements:

117002

+12 VDC 

1.7 A

+24 VDC

600 mA

+37.5 VDC

360 mA

+40 VDC

335 mA