Cisco Cisco Firepower Management Center 2000 Notas de publicación
3
Firepower System Release Notes for Version 6.0.0 Pre-Install
Updating the Firepower Management Center
Updating the Firepower Management Center
You must install the Version 6.0.0 Pre-Install to your Firepower Management Center prior to updating your system to
Version 6.0.0 if STIG is enabled,
Version 6.0.0 if STIG is enabled,
1.
Download the pre-installation file (Sourcefire_6.0.0_Pre-install-build_4.tar) from the
Note:
Download the update directly from the Support site. If you transfer an update file by email, it may become
corrupted.
2.
On the system that will be used to upload the Version 6.0.0 Pre-Install to the Firepower Management Center, extract
the file:
the file:
—
for Series 3 and virtual Firepower Management Center
Sourcefire_3D_Defense_Center_S3_6.0.0_Pre-install-5.4.1.999-4.sh
Note:
An application capable of extracting tarballs (.tar or .tar.gz) will be needed for this task. (Due to a significant number
of reported file corruption issues upon extraction, we recommend against using WinZip to handle the file extraction.) To
reduce the possibility of file corruption or alteration during transfer, do not extract the hotfix file (.sh) on a different
system, and/or transfer the hotfix file via email. We advise comparing the checksum (sha512)of the extracted hotfix file
against the respective checksum provided in the hotfix archive file to ensure a match.
reduce the possibility of file corruption or alteration during transfer, do not extract the hotfix file (.sh) on a different
system, and/or transfer the hotfix file via email. We advise comparing the checksum (sha512)of the extracted hotfix file
against the respective checksum provided in the hotfix archive file to ensure a match.
3.
Using a web browser on the same system, log into the web user interface of the Firepower Management Center.
4.
Select System > Updates.
5.
Upload the file to the Firepower Management Center by clicking Upload Update.
6.
Click Choose File in the Updates box, select the file from the local file system, then click Upload to upload the file
to the Firepower Management Center.
to the Firepower Management Center.
The Product Updates sub-tab will then appear again.
7.
Take note of the Reboot column for each file to be installed.
8.
Click the Install icon for the file.
9.
Select the device(s) to which to install the file.
10.
Click Install to begin installing the file.
11.
Confirm on the System Status tab page (Tasks > System Status) the progress of the installation, until the installation
is complete.
is complete.
Note:
The Firepower Management Center does not reboot.
Caution!
Updating a Firepower Management Center that manages devices running Version 5.4.0.6, Version 5.4.1.5, or
earlier to Version 6.0.0 may cause traffic outages and system issues. To avoid traffic disruption, you must disable the
Retry URL cache miss lookup option in the Advanced Options section of the Access Control page prior to deploying
configuration to managed devices running Version 5.4.0.6, Version 5.4.1.5, or earlier. For more information after you
update the Firepower Management Center to Version 6.0.0, see the
Retry URL cache miss lookup option in the Advanced Options section of the Access Control page prior to deploying
configuration to managed devices running Version 5.4.0.6, Version 5.4.1.5, or earlier. For more information after you
update the Firepower Management Center to Version 6.0.0, see the
section
of the Firepower System Version 6.0.0 Release Notes.