Cisco Cisco Firepower Management Center 2000 Guía De Información
3
Installing Round Hole Adapters for Square Hole Rack Slides for the Cisco Firepower 7100 Series
78-100730-01A0
Installation
Installation
Warning
Use of non-supported racks or hardware may cause the equipment to fall, which could result in
equipment damage or personal injury.
equipment damage or personal injury.
To mount a slide rail to the rack rail/vertical mounting flange:
Step 1
Screw the hex standoff into the end of the slide rail (see
).
Step 2
Repeat step 1 for each end of the two slide rails.
Figure 3
Hex Standoff to Slide Rail Ends
Step 3
Hook the adapter bracket in place behind the tabs on the end slide rail. Note that you must hold the
adapter in place, it does not latch onto the slide rail (see
adapter in place, it does not latch onto the slide rail (see
).
Figure 4
Adapter Attachment to Slide Rail Ends
Step 4
Choose a suitable rack location and identify the correct holes.
Step 5
Line the end of the slide rail (with the adapter) to the holes. The rail/vertical mounting flange goes into
the C shape (from above) of the adapter. Support the back end of the slide rail to ease assembly.
the C shape (from above) of the adapter. Support the back end of the slide rail to ease assembly.
Step 6
Install one of the four 5/8 inch Philips flat head screws with washer to hold the slide rail in place, but do
not tighten completely (see
not tighten completely (see
).
Note
There are two washers in the kit. Use one washer per slide rail.