Cisco Cisco Firepower Management Center 2000 Guía De Instalación
C H A P T E R
4-1
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
4
Setting Up the Defense Center
After you install Cisco NGIPS for Blue Coat X-Series, you must set up a Cisco Defense Center to
manage the software. These steps include obtaining the proper licenses, adding Cisco NGIPS for Blue
Coat X-Series to the Defense Center, and configuring the interfaces.
manage the software. These steps include obtaining the proper licenses, adding Cisco NGIPS for Blue
Coat X-Series to the Defense Center, and configuring the interfaces.
For more information, see:
•
Licensing the FireSIGHT System in the FireSIGHT System User Guide
•
•
For more information on configuring the FireSIGHT System, including access control policies and so
on, see the FireSIGHT System User Guide.
on, see the FireSIGHT System User Guide.
Adding Cisco NGIPS for Blue Coat X-Series to the Defense
Center
Center
You must use a Defense Center to manage Cisco NGIPS for Blue Coat X-Series. You use at least two of
three fields for configuring communications between appliances:
three fields for configuring communications between appliances:
•
Management Host
— the hostname or IP address
•
Registration Key
— the registration key
•
Unique NAT ID (optional)
— a unique alphanumeric ID (use if a NAT device separates your Cisco
NGIPS for Blue Coat X-Series installation from the Defense Center)
Valid combinations include:
•
Management Host
and
Registration Key
on both the Defense Center and Cisco NGIPS for Blue Coat
X-Series.
•
Registration Key
and
Unique NAT ID
on Cisco NGIPS for Blue Coat X-Series with
Host, Registration Key,
and
Unique NAT ID
on the Defense Center.
•
Management Host, Registration Key, and Unique NAT ID on Cisco NGIPS for Blue Coat X-Series with
Registration Key and Unique NAT ID on the Defense Center.
If you are using VAP groups, consider using device groups to parallel your VAP group configuration.
After you add Cisco NGIPS for Blue Coat X-Series to the Defense Center, use the Defense Center to
configure the interfaces, as described in
configure the interfaces, as described in
. For more
information on configuring the FireSIGHT System, see the FireSIGHT System User Guide.