Cisco Cisco IOS Software Release 12.2(13)ZG Notas de publicación

2048K bytes of processor board Web flash (Read/Write)

Configuration register is 0x0

Example of serial number reading from DSLAM:

4a 41 44 30 36 30 39 30 46 59 37 ff ff ff ff ff 0a 46 01 02 01 4a 00 00 00 00 00 00 00 00 

00 00

04a 41 44 30 36 30 39 30 46 59 37

The first 11 B of ASCII codes in hexadecimal number can be decoded as JAD06090FY7 which is 
the board ID.

ff ff ff ff ff

Five unused bytes.

0a

This byte identifies if standard upstream tone range is used. In standard Annex-B or ETSI, possible 
values are 0a in hexadecimal for 20140 chip set or 0b in hexadecimal for 20150 chip set. In Annex-B 
UR2 mode, possible values are 10 in hexadecimal for 20140 chip set or 11 in hexadecimal for 20150 
chip set.

46 01 02

These three bytes show that 20140 chip set is used by current CPE. For 20150 chip set, the display 
values will be 56 01 02.

01 4a

These two bytes show that current firmware version is 4.10.1.

00 00 00 00 00 00 00 00 00 00

The remaining 10 bytes are unused. Value is zero.

The following sections describe the documentation available for the Cisco 831, 836, and 837 routers and 
the Cisco SOHO 91, 96, and 97 routers. Typically, these documents consist of hardware and software 
installation guides, Cisco IOS configuration and command references, system error messages, feature 
modules, and other documents. Documentation is available as printed manuals or electronic documents, 
except for feature modules, which are available online on Cisco.com and the Documentation CD.

Use these release notes with the documents listed in the following sections:

The following documents are specific to Release 12.2 and apply to Release 12.2(13)ZG. They are 
located on Cisco.com and the Documentation CD (under the heading Service & Support):

To reach the 

, click this path:

:

:

 Release 12.2

:

 Release Notes

:

 Cisco IOS