Cisco Cisco IOS Software Release 12.4(23) Notas de publicación
524
Caveats for Cisco IOS Release 12.4
OL-7656-15 Rev. J0
Resolved Caveats—Cisco IOS Release 12.4(8)
Workaround: There is no workaround.
•
CSCsd41989
Symptoms: A T3 controller remains down when loopback local is configured.
Conditions: This symptom is observed on a Cisco platform that is configured with a channelized T3
port adapter when the T3 controller is in an unavailable seconds (UAS) state.
port adapter when the T3 controller is in an unavailable seconds (UAS) state.
Workaround: Remove the cause of the UAS state for the T3 controller.
•
CSCsd49253
Symptoms: A Cisco 7200 series may reload unexpectedly when an Automatic Protection Switching
(APS) switchover occurs on Packet over SONET (POS) interfaces that are configured for
redundancy.
(APS) switchover occurs on Packet over SONET (POS) interfaces that are configured for
redundancy.
Conditions: This symptom is observed on a Cisco 7200 series.
Workaround: There is no workaround.
•
CSCsd63918
Symptoms: A router reloads unexpectedly when you enter the bridge-group bridge-group
command as part of an ATM PVC configuration.
command as part of an ATM PVC configuration.
Conditions: This symptom is observed on a Cisco router that is configured with an ATM port adapter
such as a PA-A2 port adapter.
such as a PA-A2 port adapter.
Workaround: There is no workaround.
IP Routing Protocols
•
CSCeg39601
Symptoms: The IPv6 multicast RP encapsulation tunnel remains down.
Conditions: This symptom occurs on the configuration of the ipv6 pim rp-address command. The
resulting encapsulation tunnel is created but remains always in down state.
resulting encapsulation tunnel is created but remains always in down state.
Workaround: There is no workaround.
•
CSCej78303
Symptoms: A router may crash when you disable the ipv6 multicast-routing command.
Conditions: This symptom is observed when you enable and disable the ipv6 multicast-routing
command multiple times while IPv6 Multicast traffic is being processed.
command multiple times while IPv6 Multicast traffic is being processed.
Workaround: There is no workaround.
•
CSCek25582
Symptoms: Spurious memory accesses may be (continuously) generated at the
“igmp_process_timers” function.
“igmp_process_timers” function.
Conditions: This symptom is observed on a Cisco router that is configured for multicast routing.
Workaround: There is no workaround.
•
CSCek32244
Symptoms: Not all classful networks are locally generated in the BGP table.
Conditions: This symptom is observed on a Cisco router that has the auto-summary command
enabled and occurs when classful networks are provided before the routes are made available in the
routing table.
enabled and occurs when classful networks are provided before the routes are made available in the
routing table.