Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Diseño

To view details for a Google Earth Map folder, follow these steps:

From the Google Earth Map page, click the folder name to open the details page for this folder. The 
Google Earth Details page provides the mesh access point names and MAC or IP addresses.

To delete a mesh access point, select the applicable check box and click Delete.
To delete the entire folder, select the check box next to Folder Name and click Delete. Deleting 
a folder also deletes all subfolders and mesh access points inside the folder.

Click Cancel to close the details page.

You have a choice of ordering indoor access points (1130 or 1240) directly into the bridge mode, so that 
these access points can be used directly as mesh access points. If you have these access points in a local 
mode (nonmesh), then you have to connect these access points to the controller and change the radio role 
to the bridge mode (mesh). This can become cumbersome particularly if the volume of the access points 
being deployed is large and if the access points are already deployed in the local mode for a traditional 
nonmesh wireless coverage.

For local mode indoor access points prior to a mesh installation, you must first connect all indoor mesh 
access points to the controller and change the mode to bridge mode.

To do so, connect all the indoor access points (AP1130, AP1240) to the Layer 3 network on the same 
subnet as the Management IP address.

Add the MAC address of the indoor mesh access points into the MAC filter list on the controller. All 
indoor access points will then join the controller in local mode. 

You can then change local mode to bridge mode in the controller for every indoor access point (see 

).

After changing the indoor access points to bridge mode on the controller, add these indoor mesh access 
points into Cisco WCS.