Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guía De Instalación
16
Cisco Aironet 1520 Series Outdoor Mesh Access Point Mounting Instructions
78-18269-04
Mounting the Access Point
Step 4
Find Mesh Information, and enter the new BGN in the Bridge Group Name field.
Step 5
Click Apply.
Step 6
Repeat Steps 2 through 5 for each access point.
Step 7
Log out from your controller, and close your web browser.
Mounting the Access Point
This section provides instructions for installing your access points. Personnel installing the access point
must understand wireless access points and bridging techniques and grounding methods.
must understand wireless access points and bridging techniques and grounding methods.
Caution
All mounting methods on any wall surface is subject to the acceptance of local jurisdiction.
Installation Options
There are two optional installation kits:
•
Pole mount kit—used for pole, wall, or streetlight installations
•
Strand mount kit—used for cable strand installations
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1030
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Caution
To provide inline PoE, you must use the power injector (AIR- PWRINJ1500-2=) specified for the access
point. Other power injectors, PoE switches, and 802.3af power sources do not provide adequate power,
which might cause the access point to malfunction and cause over-current conditions at the power
source. You must ensure that the switch port connected to the access point has PoE turned off.
point. Other power injectors, PoE switches, and 802.3af power sources do not provide adequate power,
which might cause the access point to malfunction and cause over-current conditions at the power
source. You must ensure that the switch port connected to the access point has PoE turned off.
Refer to these sections for installation details.
•
•
•
•